About Düscha

TornOff comannd send no TLV commands to laser. PLC only set a BIT on the Ethercat.   You can check this if you go online and the show on peripheral site under Peripheral._send.LaserOn. If this set to False, then the command was set correct. The error comes if after 5 seconds no answare from laser comes. This you can check under Peripherals._recv.StateDecode.LaserOn. The lib check this variable. If this not set to false, the error from your picture comes. ... View more

You can buy for example a C6017 as sparepart from BCI and using this. With this device you have a device with our image and you have the complete range of functions that nexeedator means. ... View more

Do you used actual version of Matcontrol. All changes in our libs is from 2020.   ... View more

We used the MarkUs with windows system, and I checked the application code,  you are right, I found the ParImm.StopJob is used in the home procedure and I got the reason is that programmer wanna stop the laser system during home. but there is a bug, didn't reset the variable. we fixed the code, tested then the object, it is working well. thank you~ ... View more

Hello, this is not correct. The VPB 40.4 is a pc with Win 7 license. If you install a Control plus V2 image on this IPC, you must buy a Win 10 license seperate. we sell our image sticks without a Windows license. This license must already be present on the IPC.   If you would like using Control plus V1 on devices with Win 10 (Control plus V2 devices) you can read this knowledge base https://community.developer.bosch.com/t5/Knowledge-base/HOW-to-run-a-Control-plus-V1-program-on-a-Control-plus-V2-image/ta-p/46000 ... View more