The robot slows down significantly when passing help points. All my help points are set as blended joints, blending 50 mm post blending 50 mm (see screen). I tried changing the settings to PTP blended, but the result was the same. I discuss this with Stäubli. I sent them video trajectories, record and screenshots of setings of the points. It got through to the uniVal developers and they wondered if the correct function blocks,MC_MoveAxisAbsolute, Direct and Linear were being used and on follow up if they were waiting for the MC_GroupContinue statuses which should be the correct function block to use.
Thank you in advance for reply.
Can you send the program and the robot folder from the target system to our helpdesk (Nexeed.helpdesk(at)bosch.com ),
so that we can investigate it ?
And one more thing :
In the Logfile you move "linear blended" from the "help-points" to the "nest-offset-points" and vice versa .
If there are no collisions possible, then I would recommend that these movements also be executed as "joints blended"
Thank you for the warning, I have modified the movement from the help point to the offset point to PTP_BLENDED, since the AddOffsetRobotPointToList method removes the joint coordinates. Based on this, I tried changing all the help points to PTP_BLENDED, but the behavior here remained the same.
What exactly folder do you mean? And which program (PLC project, ...)?