07-21-2023 09:20 AM
I have a new IPC VPB40.4D2. To install the NexeedV2 image, I connected a screen with a DisplayPort connector to the VPB40.4D2.
Everything works OK, but the screen goes OFF (for 2 or 3 seconds) and ON in irregular intervals.
I have changed the DisplayPort cable and the screen. But that didn't help.
Is this a hardware problem of the VPB40.4D2 or there may be other reasons (graphic-card settings, resolution etc)
Has anyone had the similar behavior before?
07-24-2023 01:54 PM - edited 07-24-2023 01:54 PM
what display you using?
mPad, Rexroth or Beckhoff
07-25-2023 07:54 AM
I used a normal office screen (from HP). I had this behavior, when I was installing the VPB40.4D2.
07-25-2023 09:25 AM
normally you must not chnage any graphic settings.
But you can try set the display resolution down.