We are moving! We are currently migrating our community to the new Bosch Connected Industry Online Portal. The community will be available latest in the new year again, until then it will be in read-only mode. Click here for more information.
07-21-2023 09:20 AM
I have a new IPC VPB40.4D2. To install the NexeedV2 image, I connected a screen with a DisplayPort connector to the VPB40.4D2.
Everything works OK, but the screen goes OFF (for 2 or 3 seconds) and ON in irregular intervals.
I have changed the DisplayPort cable and the screen. But that didn't help.
Is this a hardware problem of the VPB40.4D2 or there may be other reasons (graphic-card settings, resolution etc)
Has anyone had the similar behavior before?
07-24-2023 01:54 PM - edited 07-24-2023 01:54 PM
what display you using?
mPad, Rexroth or Beckhoff
07-25-2023 07:54 AM
I used a normal office screen (from HP). I had this behavior, when I was installing the VPB40.4D2.
07-25-2023 09:25 AM
normally you must not chnage any graphic settings.
But you can try set the display resolution down.