About florrens

florrens · ‎10-13-2023

If I run the SetAdjustment function of an AnalogInput 1.2.17.0 my StationData is emptied: all values set to 0 or empty strings. I have configured the AnalogInput as follows and use the _saveData method below. Is this method not suitable to handle the data storage for the AnalogInput? (what else should be connected to rSave instead?)

florrens · ‎10-10-2023

I wonder how I can get a delayed State.Gen.Empty.On signal from the NexeedStateAddon by using the ParImm.Empty / ParImm.EmptyDelay inputs? If I see correctly in the open lib then the Empty.On signals of the modules are only delayed if no ParCfg.rIsModuleEmpty is configured. However the addon configures these signals automatically during export since the IsEmpty is always found if an OpconModeHandler is used. So the following code in my application will never have an effect: I found a solution which could also be called workaround, so I wonder if this is the actually the intended solution or if it has side effects? Set ManualConfigStationEmpty in CpS and leave the Module1Empty

florrens · ‎10-04-2023

Is there a possibility available to trigger an automatic HMI restart of a hot-plug mPad after a deployment to the IPC to get the new HMI directly on the hot-plug mPad? yes: how? no: is it possible to put that on a new feature list?

florrens · ‎07-13-2023

Will it be possible to update projects directly from CPS 5.6.2 to CPS 5.8 ? We currently have several projects running von 5.6.2 and I consider to update them to 5.8. However I would like to skip the intermediate step via 5.7 if that is possible

florrens · ‎06-20-2023

Can I use WaitBool / WaitIo then to solve the following case? I want to continue in my step chain only if 2 independent signals are present at the same time. If one signal was present but gets lost while waiting for the other signal I do not want to continue. For my understanding I cannot use 2 steps one ather the other since I then cannot check the first signal while waiting for the 2nd signal. Also two parallel steps will not work if I use a wait step ("wait for other branch") in each branch. When one of the signals was present (e.g. the first signal) this branch will forward to the wait step (_retVal := OK;). Since there is no monitoring in this step I will not notice when the first gets lost while waiting for the 2nd signal.

Bosch Shared

About florrens

StationData is emptied if AnalogInput SetAdjustment function is used (rSave variable is co...

How to get a delayed State.Gen.Empty.On signal from the NexeedStateAddon ?

Restart mPad hot-plug HMI automatically after IPC deployment?

CPS 5.6 to CPS 5.8 update possible?

Re: WaitIo, WaitBool functions

About florrens

StationData is emptied if AnalogInput SetAdjustment function is used (rSave variable is co...

How to get a delayed State.Gen.Empty.On signal from the NexeedStateAddon ?

Restart mPad hot-plug HMI automatically after IPC deployment?

CPS 5.6 to CPS 5.8 update possible?

Re: WaitIo, WaitBool functions

Still looking for something?