About SteffenR-

SteffenR-

As mentioned the SecondHmi runtime is the solution to just show one view on an additional monitor: The cheapest solution by hardware costs is probably a USB monitor or USB-to-X adapter. The overall costs are probably more expensive. It requires additional drivers, i.e. if there is no (regular) image backup of the target system or documentation how to setup the target system, a PLC exchange or update of Control plus Master Image is more difficult. Furthermore I have also seen problems with such a solution like flickering display. Support by Bosch Connected Industry will be very limited in these cases.

SteffenR-

You will get an answer next week from our application team. Meanwhile of course everybody else can share his/her experience 😀

SteffenR-

Please use the peripheral NexeedEcBcTwinSafeLogic ("Twinsafe Logic") which covers the logic terminals EL6900, EL6910 and EL1918. Depending on the number of slaves of which you want to link the signals into the PLC (not into TwinSAFE), you can choose one version with 0, 25, 50, 75 or 100 slaves. Higher number means slower Reload Std.

SteffenR-

For which pressure level (German: DruckNiveau) do you use the SafetyValve add-on? DN10, DN11, DN12? And which Performance Level (PLc, PLd, PLe) do the pneumatic movements have ? The SafetyValve add-on is designed to monitor either two physical safety valves or one physical safety valve + Aventics U_A voltage (see PDF in documentation): or The latest Bosch Norm N54 D2 actually allows a new setup. Do you have such a use case? If yes, the current solution would be to use a BinIo flag for the second parameter IsValve2Off.

SteffenR-

You have to check your EPLAN: Does K986/K987 logic (which is also switching the safety valve K086/K087) switch off U_A voltage of the valve system? If yes => check your wiring or safety logic (PNOZmulti, TwinSAFE, etc.) If no => do not connect this AES channel to SafetyValveAddon.

Bosch Shared

About SteffenR-

Re: Additional HMI with static view

Re: How to understand WpcSeparation object and its parameters properly?

Re: Beckhoff EL6910 support

Re: AES-D-BC-ECAT Gen2 - Voltage UA should be OFF error throwing a CANCEL

Re: AES-D-BC-ECAT Gen2 - Voltage UA should be OFF error throwing a CANCEL

About SteffenR-

Re: Additional HMI with static view

Re: How to understand WpcSeparation object and its parameters properly?

Re: Beckhoff EL6910 support

Re: AES-D-BC-ECAT Gen2 - Voltage UA should be OFF error throwing a CANCEL

Re: AES-D-BC-ECAT Gen2 - Voltage UA should be OFF error throwing a CANCEL

Still looking for something?