Unusual behaviour in HMI

[amm]

HMI shows violet colors in the project tree with cone icons. Never seen before.

Image attached.

Control on is allowed, ethercat bus is correct and nexeed license is also working. Every unit is in operational state.

[MarvinW · Accepted solution]

The cone means that this unit's Dummy Command Mode (DCM) is turned on. The violet color I am not sure. Is your simulation mode enabled?

[nexidator · Accepted solution]

The violet color in this place also means Dummy Command Mode. 

Yes, the violet color is also used to indicate simulation mode in the mode switch. The same color is used because DCM and simulation are somewhat related: In both cases, the machine hardware won't move.

[amm]

Thank you!