About LlobetAtWork

Hi,  So I made a cert folder in the root of sd card and put the ca.pem file in that folder. Then followed the instruction of this page (from bosch site).  I exported the WiFi_firmware_update.zip and first flash and run the WifiHostProrammer. This output the messages "writing certificate /cert/ca.pem...file write complete" message. So this means the wifi module has been upgraded and the certificate has been read successfully. Then I flash and run the EnterprizeWifi. But the connection to the wifi is not established. Also no error messages.   What might go wrong? ... View more

Hi Taz0r, the PR21 and the IoT Gateway project is mantained by Bosch Rexroth. The PR21 uses the bluez Linux service for the BLE functionality and in their documentation you can find the adapter used ( LM Technologies Bluetooth® v4.0 Dual Mode Long Range USB Adapter – LM1010 ) The PR21 supports the BCDS & Rexroth products CISS and SCD which have different protocols / BLE interfaces than the XDK. For development purposes, the XDK team used BLED112 USB adapters from Bluegiga to test devices using the python libraries.   ... View more

Thank you for explaining but now, I recieved a new error AppControllerFire : MQTT connection to the broker failed INFO | XDK DEVICE 1: Error in WLAN package. INFO | XDK DEVICE 1: Package ID: 10 INFO | XDK DEVICE 1: Module ID: 3 INFO | XDK DEVICE 1: Severity code: 2 INFO | XDK DEVICE 1: Error code: 1 My MQTT broker is working fine when I tested it with mita application, but for SendOverMQTT it is showing the above error. I even updated the wifi firmware, still no change. Can you help me? ... View more

Hi hemanthm , the packet rates 10ms or 5ms are not supported by BLE.  The time between packets in BLE is called connection interval and this is limited, for example in iOS to 15ms (https://developer.apple.com/accessories/Accessory-Design-Guidelines.pdf) . Also due to thermal management and duty-cycling, every 4 packets there will be a  larger pause between packets. The recomendation to increase payload (up to a certain point) is to pack the most amount of data points into the characteristic's payload. Besides that, BLE is usually not the recomended physical layer for high-troughput telemetry. Best regards, Francisco Llobet ... View more

Hello Stephan, a (generic) queue error comes from some un-initialized module caused by either some memory allocation problems while creating the queue or some missed initialization of the module. Is this native C code or Mita code? Do you have the LoRA extension properly connected? Best regards, Francisco LLobet ... View more