About nexidator

nexidator · ‎11-26-2021

English 🠦 Deutsch HMI modulo V4.11c Bugfixes Mod_ManualFunctionKey throws exception in HMI view designer in OES Mod_TransparentArea: State of child units was not shown Color of frame did not change if header was not used Deutsch 🠦 English HMI modulo V4.11c Fehlerbehebungen Mod_ManualFunctionKey wirft einen Ausnahmefehler im HMI-Ansichten-Designer in OES Mod_TransparentArea: Status unterlagerter Units wurde nicht angezeigt Rahmenfarbe änderte sich nicht wenn kein Header verwendet wurde

nexidator · ‎11-23-2021

What version of OES are you using? Support for the TwinCAT XAE shell has been introduced in V4.10.4 (aka 4.10d). Which tool is opened when you double-click the solution? When opening the solution from a different version, you need to explicitely save the solution in order to change the tool that will be used to open the solution next time you double-click it.

SteffenR- · ‎11-22-2021

If you get an error "Maximum count of xxx per handler exceeded": For every method there is an own parameter that can be changed in the library manager in the OpconBase / NxBase library. After changing a library parameter you should do a clean project/solution and activate configuration! Keep in mind that increasing these library parameters also increases the PLC cycle time / CPU load. AddUnit => OPCON_HANDLER_CHILDS_PER_HANDLER AddAddon => OPCON_HANDLER_ADDONS_PER_HANDLER AddCommand => OPCON_HANDLER_CMDS_PER_CMDHANDLER AddMode => OPCON_HANDLER_MODES_PER_MODEHANDLER (this is also used for CmdHandler in Control plus V2) AddSubchain => OPCON_HANDLER_SUBCHAINS_PER_HANDLER

nexidator · ‎11-19-2021

English 🠦 Deutsch Control plus HMI V5.2.1 Bugfixes Minimize mosquitto window after start Mod_Grid: Value of VWItemSelectedRow is incorrect in some cases Mod_TransparentArea: Color of frame did not change if header was not used Back navigation for views requested by the PLC was sometimes not correct Some nodes in the machine tree were not updated correctly Deutsch 🠦 English Control plus HMI V5.2.1 Fehlerbehebungen Mosquitto Fenster wird nach dem Start minimiert Mod_Grid: VWItemSelectedRow liefert in bestimmten Situationen einen falschen Wert Mod_TransparentArea: Rahmenfarbe änderte sich nicht wenn kein Header verwendet wurde Zurücknavigation für von der SPS angeforderte Ansichten funktionierte manchmal nicht korrekt Einige Knoten im Maschinenbaum wurde nicht richtig aktualisiert

nexidator · ‎10-25-2021

Thanks for your input! This would even be an argument against aligning any code at all. We still prefer aligning assignments for readability reasons. But you are right, aligning the commas does not make much sense. We will change this in Control plus Studio 5.3, but not in any compatible OES updates. BTW: The blanks at the end of the comment have already been removed in OES 4.11 and CpStudio 5.0.

Bosch Shared

About nexidator

HMI modulo V4.11c

Re: TcXaeShell update issue

Re: Child unit count - Children per command handler

Control plus HMI V5.2.1

Re: OES/CPS change request

About nexidator

HMI modulo V4.11c

Re: TcXaeShell update issue

Re: Child unit count - Children per command handler

Control plus HMI V5.2.1

Re: OES/CPS change request

Still looking for something?