10-18-2022 11:42 AM
Hello,
I am using LMi Gocator Object for communicating between CX2020 and Lmi Gocator camera.
The communication is established and the trigger functions works in manual mode.
When I give Start and stop from PLC, LMI is accepting.
The only challange what i am facing is, how to get the result data from the LMI.
I dont know where to set in the LMI software to get the result data to the PLC like - Pass/Fail or Measured values.
I came to know, this Object is used in AnP plant from BCI and when i sent a mail to the TEF of AnP I am not getting any response/replies.
Request the developer or the one who have used this object to help me on this topic.
10-18-2022 01:15 PM - edited 10-18-2022 01:15 PM
I don't know the device or the object - but when I look into the object documentation,
there is a result section in the OutImm variables....
Maybe this is what you are looking for ?
10-18-2022 01:29 PM
Hello Thorsten,
Thankyou for your replay........!
Yes, results are available as per the object document But,
I am looking the solution in the device side.
Where we have to set the results in the device?