We are moving! We are currently migrating our community to the new Bosch Connected Industry Online Portal. The community will be available latest in the new year again, until then it will be in read-only mode. Click here for more information.
10-18-2022 11:42 AM
Hello,
I am using LMi Gocator Object for communicating between CX2020 and Lmi Gocator camera.
The communication is established and the trigger functions works in manual mode.
When I give Start and stop from PLC, LMI is accepting.
The only challange what i am facing is, how to get the result data from the LMI.
I dont know where to set in the LMI software to get the result data to the PLC like - Pass/Fail or Measured values.
I came to know, this Object is used in AnP plant from BCI and when i sent a mail to the TEF of AnP I am not getting any response/replies.
Request the developer or the one who have used this object to help me on this topic.
10-18-2022 01:15 PM - edited 10-18-2022 01:15 PM
I don't know the device or the object - but when I look into the object documentation,
there is a result section in the OutImm variables....
Maybe this is what you are looking for ?
10-18-2022 01:29 PM
Hello Thorsten,
Thankyou for your replay........!
Yes, results are available as per the object document But,
I am looking the solution in the device side.
Where we have to set the results in the device?