We are moving! We are currently migrating our community to the new Bosch Connected Industry Online Portal. The community will be available latest in the new year again, until then it will be in read-only mode. Click here for more information.
01-25-2021 07:54 PM
Hi everyone,
my name is Clemens Wodtke, for my Bachelor Thesis in Computer Science at the University of Bremen, Germany I would like to analyze the functionality and the security of the Bosch IoT Remote Manager. The idea is to get an understanding of the software that is used to manage a large amount of devices and thus getting an small insight into the security of a program used for the IoT.
Now my professor received a license for the Bosch IoT Remote Manager 7.1 I can work with in the upcoming months. After setting up the RM I am confronted with the task of setting up a simple test device but have no idea how I could achieve this.
The quick start guide for the Cloud Based Remote Manager provides a "Demo IoT Runtime" I assume can be used to simulate a gateway or end device that can be accessed with the RM.
I am looking for advice on how I could set up or simulate a simple device I can control with the RM software.
Unfortunately I also have no prior knowledge of OSGi or IoT in specific but obviously I'm eager to learn.
So, is my understanding correct that the simplest device to set up would be a linux device with the OSGi framework?
And if that is true what are the steps necessary for this?
I apologize for the "stupid" questions but my research hasn't got me any further yet. Besides that I really hope that is the right place to ask this question, I will also try my luck on StackOverflow.
Thanks for reading and have a great day
02-17-2021 08:27 PM
Hi clemensw, again this is just community discussion and not tech support to you,
However I have noted several potential problems/suggestions which I list below, I recommend read through them all first, and try some or all of these suggestions, but especially #2, you need to extract/install Connectivity pack. I don’t think it will run without that properly extracted to the runtime.
That’s about all I know, so good luck!
02-26-2021 07:06 PM
Hi @pdo,
Thanks for bringing up good points!
I now changed my approach and will try to to use the cloud services as a starting point.
In consultation with my professor I will now give the Edge Services a try, instead of the Remote Manager. I'm honestly also struggling there but I might make a new post about that.
My basic problem is just that I dont understand the system really well although I've read through a lot of the available documentation. Every single step in the tutorials causes me further issues that I dont understand.
Regarding the technical support: The Bosch support isn't answering any of my mails so I just have to try my luck in online forums and this one here seems to be the best bet.
Thank you for your replies again