Update: Setting the QoS to 1UL exhibits a continuous connection for around 20-25 minutes, as you rightly mentioned. Is there a way to improve in this further? Thanks
... View more
Hello, Thanks for your help so far. I was able to try this with Mosquitto 1.5.6 and unfortunately, I face the same issue. It disconnects with the same frequency. But this time I do not see any error message at Broker end. kindly help.
... View more
Hello Francisco, Thanks a lot. I am having a hard time downgrading to mosquitto1.5.6 . Is there a workaround for avoiding this disconnection? May be by changing MQTT protocol version on XDK side or on the broker(if possible) ? Also, do you recommend any other broker I can use, which is known to work flawlessly with the example code?
... View more
Hi Padma, Thankyou for your reply. I am using XDK 3.6.0 with mosquitto broker, are you aware of any known issues with mosquitto. Could you please share where can I find this reconnection logic? And Could you please translate this error code? Thanks again
... View more
I simply imported the SendDataOverMqtt template and setup wifi and Mqtt structs. Along with this I just added accelerometer data to be published along with pressure, temperature and light data. XDK sends data for about 2-3 minutes and then errors out. Error in XDK workbench: Error in XDK110 Application package. Package ID: 153 Module ID: 39 Severity code: 2 Error code: 130 AppControllerFire : MQTT publish failed Error at Mosquitto broker console: Client XDK_FS disconnected due to protocol error. Code is too big to be attached, but I only edited the following sections. 1) MQTT and Wifi Setup struct 2) enabled the accelerometer in sensor struct and added it's values to snprintf(which works). Please help me decode this error.
... View more
