Modified version: point names ending in _H are help points, points ending in _OFFSET are offsets of the corresponding points, offsets are only from nest positions.
Trajectories from line 353.
We find that the traversal of points WP137_NEST_H, WP138_NEST_H, WP132_NEST_H, WP131_NEST_H, WP134_NEST_H, WP135_NEST_H, WP136_NEST_H, is not smooth.
Thank you in advance
What I have already noticed is, that the motion parameter for the help points are only configured with 80% speed,
in comperation to the nest points with 100% speed.
But that would probably be too easy, as if that had already been the problem.
So we will investigate it a little bit more in detail to see if we notice anything else.
I know about the reduced speed of course, the problem is not in the whole movement, but only when passing through the blending and post blending areas.
Would it be possible for you to make a video of the process so that we can better imagine what is happening?
And have you tried if it gets better/worse when you reduce/increase the blending distances ?
In unfavourable situations, the "slowest" axis determines the maximum possible speed.
This happens either when an axis is close to the axis limit or often when the robot has to change its configuration to reach a point.
In your log file the configuration change happens for example between the points : WP103_LOAD_H and HOME_H ,
but without seeing the sequence it is difficult to judge whether this is really a problem in the situation...
The video is shot in one sequence only, because of the size.
I tried changing the blending and the difference was not measurable.