accelerometer and gyroscope readings (x, y, z) from BMX160 over i2c is zero

[Sajilv]

Hi,

We are connecting bmx160 to nrf52 DK board over i2c. The x,y,z readings are zero from both accelerometer and gyroscope.

Followed this https://github.com/BoschSensortec/BMI160_driver/wiki/How-to-use-an-auxiliary-sensor-or-magnetometer-...TWI initialization, BMI160 initialization, accelerometer and gyroscope set config is success. After that x,y,z readings are zero from both accelerometer and gyroscope.

[LlobetAtWork]

Hi Sajilv,

Are you connecting a BMX160 to a Bosch XDK110 or is it another board?

Else, you need the support from Bosch Sensortec for their hardware.

Regards,

Francisco

[pdo · Accepted solution]

Hi Sajilv, if it's not for XDK, here is the preferred board for Sensortec questions, can you ask there?

https://community.bosch-sensortec.com/t5/Bosch-Sensortec-Community/ct-p/bst_community

Thank you!

[Sajilv]

Using nordic nrf52 dk board.

[Sajilv]

Ok, i'll post the question there.

Thanks