I'd like to use datarates above 100Hz with the Magnetometer. Using forced mode in low power should make it possible to use 300-340 Hz maximum.
I found thedefiniton of the functions :
At SDK > xdk110 > Platform > Sensors > include > BCDS_Magnetometer.h ..
My question is.. Where do i use this functions? In the AppController.c?? At the initialization of the sensor?
Go to Solution.
You can configure the Magnetometer, after sensor initialisation Magnetometer_init().
Initialization and configuration of Magnetometer is implemented in SDK\xdk110\Common\source\Sensor\Sensor.c Sensor_Enable().