Signal "enable door bridging" not comming, problem with safety door add-on

[Lipek]

Hi,

I would like to use enabling switch in my project, but I cannot do the door brigding, which is necessary to do this. Electrical connections are ok, when I'm turn the bridging key thle lock/unlock lamp is blinkig, but when I try to unlock safety door the message " Bridging of safety door not allowed" appear. This message comes from safety door add-on. 

As far as I know, the station should be in manual mode to do the door bridging, and control on should be set to "true". Are any other conditions requied?

[SteffenR-]

SafetyDoorAddon.ParImm.EnableBridging := TRUE is missing.

The safety door add-on does not know the current operation mode, it just checks ParImm.EnableBridging. Therefore you must set this variable in all modes that allow bridging (and don’t forget to reset it in other modes).