CodeMeterCC.exe - Ordinal Not Found

[wto2fe]

I have serveral Twincat Versions on my computer. For supporting an older project, I have installed TC31-RM-Setup.3.1.4020.56 on my computer. Installation runs successfully.

Now, after If I start my computer everytime comes this fault message:

TwinCat works without any faults.

[nexidator]

I remember we had some discussions with Beckhoff about the TwinCAT installer that brought some outdated CodeMeter components that TwinCAT doesn't even use at all. Maybe this is still the case in the RM Setup for 4020.

I would suggest you try to repair the CodeMeter runtime by re-installing it. It is available at Wibu for download: User Software - Wibu-Systems

[wto2fe]

The Problem withe CodeMeter fault message is solved, after I have reinstalled CodeMeter.

But I have an second problem. After installting TC31-RM-Setup.3.1.4020.56, Im only able to open 4020 Project. If I open an other Project (4022) then comes this mesaage:

The PlcProject is not part of the project

[nexidator · Accepted solution]

There are some hints about the installation order in this article: TwinCAT XAE Changelog (bosch.com)

If I understand the article correctly, you need to install a later RM after 4020.